Dexcom G6 Sensor Armband Holder Guardian Protects Sensor Black

IMPORTANT CUSTOMER NOTICE: The elastic has been Threadlocked using "Pyrm Fray Check" fabric glue at each end to prevent fraying of the fabric, if you cut down the fabric to make the arm band shorter you WILL need to super glue the ends again. It is possible to use the flame/candle trick but this may leave burn marks on the fabric.**PLEASE NOTE: SENSORS ARE NOT INCLUDED! THIS IS ONLY FOR THE ARM BAND ONLY** This is a 3D Printed product and has been through many refinements over the last few months, I am now happy to bring my Dexcom G6 to you! It is designed to protect your attached sensor and make it less likely that a knock will dislodge it. It is great to use it when moisture or contact may make the sensor come loose. Designed and worn by a type 1 diabetic. My Dexcom G6 holder will come assembled, you are required to make a few adjustments so it sits well on the arm, i wouldn't recommend putting it on to tight. If you plan to go swimming or doing extreme exercise, i recommend buying more then 1, see below for extra discount if you order more then 1 holder. At least you can wash one while wearing the other. If you find you have a lot of excess strap after you have adjusted it you can cut the excess off and seal the edge with flame.